American DJ Mega Par Profile Pack

Features

• Four Mega Par Profile

  • Ultra bright slim flat black Par with 108 10mm LEDs (26 Red, 46 Green, & 36 Blue LEDs)
  • Smooth RGB Color Mixing (fast or slow color change operation)
  • Power & DMX Ins/Outs sit sideways so the unit can be set flat on the ground or set inside truss
  • Great as an architectural wall wash or for performance stages where traditional stage lighting emit a lot of heat onto performers
  • 7 DMX Channel modes: 1, 2, 3, 4, 5, 6 or 7 channel modes
  • 5 Operational modes: Auto mode and sound active feature with built-in programs
  • Stand Alone or Master/Slave Configuration
  • Beam Angle: 30 degrees
  • 32 built-in Color Macros
  • DMX-512 protocol
  • Color strobe effect
  • Linkable via 3-pin XLR cable
  • Electronic Dimming: 0-100%
  • Includes dual mounting brackets to hang on truss, mount on a wall or set on the ground
  • Long Life LEDs (50,000 hrs.)
  • Power Draw: 18W Max
  • IEC AC input and output on rear to daisy chain power
  • Compatible with ADJ LED RC wireless infrared remote control up to 30 ft./ 10M (sold separately)
  • Multi-voltage operation: AC 90V-240V 50/60Hz
  • Dimensions (LxWxH): 9”x8.75”x3.5”/ 225x220x85mm
  • Weight: 3 lbs./ 1.1 kg.

• RGB 3C Light Controller

  • The RGB3C is a basic 3-channel RGB LED controller. It was designed to control any standard 3 channel RGB fixture where channel 1 is Red, channel 2 is Green and channel 3 is Blue. All LED fixtures must be set to run in DMX mode and be addressed to DMX channel 1. The units control panel includes nine direct access “Static Color” buttons, which contain pre-programmed color presets, 3 manual RGB faders so a desired color could be set on the fly, a Program select button which allows for 7 static colors and 10 chase programs to be accessed via the program select fader, a Sound Active button which activates the 10 chase programs to randomly sequence via an internal microphone, a Auto run button also activates the 10 chase programs to randomly sequence while the speed of the chases can be controlled via the Speed fader, a Hold button pauses the current scene and will remain locked in even when power to the controller is switched off and on, and finally a Blackout button to bring all values to zero so there is no output going to your fixtures. It’s the ideal control solution for D.J.’s, small night Clubs, and bars that want a simple LED controller to run the show.
  • DMX output connector: 3-pin XLR
    
  • Power In: 9-12V 300mA (Included)
    
  • Power consumption: 3.6 Watts
    
  • Size: 8.7” x 5.5” x 2.5” (22 x 14 x 6.3cm)
    
  • Weight: 1.8lbs. (0.8kgs.)
• FREE Connecting Cables